Flange/Driveshaft Ring

Flange/Driveshaft Ring

Special tools, testers and auxiliary items required

• Needle Bearing Drift (VW 295 A)

• Thrust Plate (VW 402)

• Punch (VW 408 A)

• Support Channels (VW 457)

• Separating Device 22 to 75 mm , for example (Kukko 17/1)

Removing the Ring - A - from the Flange/Driveshaft





B Separating tool 12 to 75 mm , for example (Kukko 17/1)

Ring Installed Position - A - on the Flange/Driveshaft





• The ring - A - must be installed with the elevation - arrow 1 - into the chamfer - arrow 2 - on the flange - B -. The smaller outer circumference face the flange - arrow 3 -.

Installing the Ring - A - onto the Flange/Driveshaft





• The ring - A - must clip into the chamfer in the flange => [ Ring Installed Position on the Flange/Driveshaft ].