Selector Lever Handle, Through MY 2011 Without RS5

Selector Lever Handle, through MY 2011 without RS5

Special tools, testers and auxiliary items required

• Trim Removal Wedge (3409)

• Hose Clip Pliers (V.A.G 1275)

Removing






- Press the button on the electro-mechanical parking brake to activate it.

- Move the selector lever into "N".

• Both the selector lever handle and the selector lever boot are removed.

- Carefully pry out the selector lever boot on the side using the (3409) - arrows - and fold it upward.

- Secure the locking button in the removed position with a cable tie - arrow -, as shown in the illustration.






- Fold the selector lever boot - 1 - upward and over the selector lever handle - 2 -.






- Open the clamps - arrow - and remove the selector lever handle along with the selector lever boot, without pressing the locking button.

Installing






• In order to install the selector lever handle, the locking button must be pulled out all the way and secured either with a cable tie - arrow - or with the assembly tool supplied with a new handle.

• Do not use mechanical aids or tools to remove from the selector lever handle if the locking button was unintentionally left unsecured. Position the compressed air gun under the handle and press the locking button out with compressed air.

- Clamp on the new clamps - arrow - onto the selector lever handle.






- Install the shifter lever handle completely on the shifter lever. The lock button faces toward the driver.

• The handle must lock into the selector lever ring groove.

- Remove cable ties or assembly tools. The locking button mechanism will engage in the vertical groove on the selector lever. If necessary, press the locking button into the selector lever handle.

- Move the button mechanism through "R" and "S" to perform the function test.

• If the selector lever positions cannot be reached, remove the handle again. Refer to => [ Selector Lever Handle, through MY 2011 without RS5 ].

- Secure the selector lever handle - 2 - to the selector lever with the clamp - arrow -. Use (V.A.G 1275).

- Install the selector lever boot frame - 1 - to the center console.