Procedures

Selector Lever Cable, Bringing into Basic Setting

Special tools, testers and auxiliary items required

• Vehicle Diagnostic Tester

• Pry Lever - Rmv Outside Mirror (80 - 200)

• Socket and Key (T40031)

Procedure

• Guided Fault Finding with the vehicle diagnostic tester is completed; all faults have been corrected.

- Select the following menu points from the vehicle diagnostic tester in the Functions/Component Selection for the "Guided Fault Finding" :

• Drive

• 0B5 Transmission

• 01 - On Board Diagnostic (OBD) Capable Systems

• 02-Transmission Electronics

• 02-Transmission Electronics, Functions

• 02-Measured Values

- Select Driving Mode from the list.

- Compare the following displays:

• Measured value Driving Mode on the vehicle diagnostic tester

• Selector lever position

• Selector lever transmission range position display unit (Y26) on the shift mechanism

• Transmission range display (Y6) in the instrument cluster

Conditions:

• The displays must match

If the displays do not match:

- Adjust the selector lever cable. Refer to => [ Selector Lever cable, Adjusting ] Adjustments.

If the individual displays cannot be reached by adjusting the selector lever cable:

Selector Lever Cable, Bringing into Basic Setting






• Tightening specifications, refer to => [ Selector Lever Cable Overview ] Selector Lever Cable Overview.

- Remove the ball socket - 2 - from the selector lever using a (80 - 200).

• Do not bend or kink the selector lever cable.

• Ignore - 1 -.

- Push the selector lever - 1 - on the transmission all the way to the back - arrow - until the parking lock locks into place.






• When parking lock is engaged, it must not be possible to turn the front wheels.

- Push the selector lever into "D".

- Make sure the selector lever inside the vehicle is also in "D".

- Insert the (T40031) through the opening - arrow - in the selector mechanism and loosen the bolt on the selector lever cable approximately one turn.






• Only loosen the clamping screw - do not remove it.

• The clamping screw is only accessible when the selector lever is in "D".

• The selector lever must remain in "D" when the clamping screw is loose.

- Remove the (T40031) from the torque wrench and let the move it through the opening - arrow - in the selector mechanism.

- Carefully press the selector lever cable ball socket - 2 - in this position onto the selector shaft lever.






• Do not bend the selector shaft lever when pressing it on, otherwise the shift mechanism can no longer be adjusted precisely.

• Ignore - 1 -.

- Select 02-Measured Values in Guided Fault Finding 02 transmission electronics on the vehicle diagnostic tester

- Select Driving Mode from the list.

- Compare the following displays:

• Measured value Driving Mode on the vehicle diagnostic tester

• Selector lever position

• Selector lever transmission range position display unit on the shift mechanism

• Transmission range display in the instrument cluster

Conditions:

• The displays must match

- Carefully move the selector forward and back gently without shifting into another selector lever position. This releases the tension in the selector lever cable.






- Tighten the clamping screw in this position with the (T40031) without touching the selector lever.

- Check the selector mechanism. Refer to => [ Selector Mechanism, Checking ] Procedures.