Right Flange Shaft

Right Flange Shaft

Special tools, testers and auxiliary items required

• Needle Bearing Drift (VW 295)

• Slide Hammer-Complete Set (VW 771)

• Lifting Eyebolt (3368)

• Oil Collecting and Extracting Device (V.A.G 1782)

• Engine and Transmission Holder (VAS 6095)

• Grease Parts Catalog

• M10 nut, quantity: 2

Removing

• Secure the transmission to the (VAS 6095). Refer to => [ Securing on Engine and Transmission Holder ] Securing On Engine and Transmission Holder.

- Place the (V.A.G 1782) under the transmission.






- Install the (3368) into a threaded hole in the right flange shaft.

- Mount (VW 771) with pulling hook (VW 771/13) on the (3368) and remove the flange shaft.

Installing






Install in reverse order of removal. Note the following:

• Replace the circlip on the right flange shaft.

- Clamp the flange shaft in a vise with jaw protectors. Remove the old circlip from the groove in the flange shaft using the new circlip - A -.

- Fill the space between the sealing- and dust lip half way with sealing grease; for the correct sealing grease, refer to the Parts Catalog.

- Drive the right flange shaft in using the (VW 295).

- Fill with Manual Transmission Fluid (MTF).