Shock Absorber, FWD

Shock Absorber, FWD

Special tools, testers and auxiliary items required

• Torque wrench (V.A.G 1332)

• Shock absorber set (T10001)






1 Stone Protection Plate

2 Shock Absorbers

• Only shock absorbers with the same part number may be installed on the left and right.

• Removing and installing, refer to => [ Shock Absorber ] Shock Absorber.

• Note different types of suspension versions, see vehicle data plate, refer to => [ Production Control Number (PR Number) Explanations ] Application and ID.

• Faulty shock absorbers must be vented and emptied before disposal. Refer to => [ Rear Gas-Filled Strut, Venting ] Rear Gas-Filled Strut, Venting.

• Check removed shock absorber. Refer to => [ Shock Absorbers, Checking when Removed ] Shock Absorbers, Checking When Removed.

3 Washer

• Always use.

4 Protective Sleeve

5 Buffer Stop

6 Upper Shock Absorber Mount

7 Nut

• 35 Nm

• Always replace if removed.

8 Cover

Loosening and Tightening the Nut





1. Ratchet (commercially available)

2. Socket wrench 21 mm (T10001/9)

3. Ratchet (T10001/11)

4. Socket wrench 21 mm (T10001/1)


Upper Shock Absorber Mount Installation Position





- Install the upper shock absorber mount so it is rotated 90° to the lower shock absorber mount.