Fuse Panel B In Engine Compartment E-Box

Fuse Panel B in Engine Compartment E-Box

Removing






- With the ignition switched off, disconnect the negative battery cable. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

- Remove the washer fluid reservoir filler neck. Refer to => [ Washer Fluid Reservoir Filler Neck ] Washer Fluid Reservoir Filler Neck.

- Remove the bolts - arrows - and the engine compartment E-box cover.

• Disregard item - 1 -.

- Release the retainers - A arrows - and remove the Engine Control Module (ECM) - arrow B -.






- Disconnect the connector - 2 - if applicable.






- Disconnect the electrical connectors - 4 - and remove the electrical wire - 3 -.

- Open the retainers - arrow - and remove fuse panel B - 1 -.

- Disengage engine wiring harness from the E-box and lay the wire off to the side.

- Remove the electrical wire - 5 -.






- Remove the relay - 3 - and control modules - 4 - from the fuse panel B.

- Release the retaining clip - arrow -, push the fuse panel - 2 - back and out and disengage it.

- Release the retaining clip and press the auxiliary fuse panel - 1 - back and out.

- Release the retaining clips - arrows - and press the relay carrier - 2 - back and out of the bracket - 1 -.






- Remove fuse panel B from the engine compartment E-box.

Installing

• Tightening specifications, refer to => [ Fuse Panel B in Engine Compartment E-Box, Tightening Specifications ] E-Box, Wire Junction, Fuse Holder and Battery Overview.

Install in reverse order of removal, observing the following:

- Install the washer fluid reservoir filler neck. Refer to => [ Washer Fluid Reservoir Filler Neck ] Washer Fluid Reservoir Filler Neck.

- Connect the battery. Refer to => [ Connecting ] Battery, Disconnecting and Connecting.