Inner Tail Lamp

Inner Tail Lamp

Special tools, testers and auxiliary items required

• Trim Removal Wedge (3409)

Observe the notes on contact corrosion. Refer to => [ Contact Corrosion ] Service Precautions.

Removing

- Switch off the ignition and remove the ignition key.

- Turn the light switch into the "0" position.

- Pry the cover - 1 - out using a (3409) - arrow -.

- Disconnect the electrical connector - 5 -.






- Remove the nut - 2 - and the clamping bracket - 1 -.

- Remove the nut - 4 - and the clamping bracket - 3 -.

- Remove the inner tail lamp toward the outside.

Installing

Install in reverse order of removal, observing the following:

• Tightening specification, refer to => [ Inner Lamps ] Inner Lamps.

• Make sure the seal between the body and tail lamp seals correctly.

- Position the inner tail lamp on the outer edge of the rear lid.

- Slide the clamping bracket - 3 - onto the inner tail lamp threaded pins and install the nut - 4 - loosely.






- Slide the large clamping bracket - 1 - onto the threaded pins on the inner tail lamp and tighten the nuts - 2 - and - 4 -.

• When tightening the nuts, the clamping bracket wedges itself onto the rear lid - arrows -.