Side Instrument Panel Vent

Side Instrument Panel Vent

• Removal and installation are same for right and left.

Special tools, testers and auxiliary items required

• Hook (3438)

Removing






• The instrument panel vent has a hole on both sides for attaching the hook (3438).

- Alternating between the sides, carefully remove the instrument panel vent - 1 - from the installation opening using the (3438).

- Vehicles with illumination: Disconnect the connector on the instrument panel vent.

Installing

Installation is reverse of removal, but note the following:

• Check the clips for damage or deformation and replace them if necessary.

- When sliding the instrument panel vent into the installation opening, make sure the air duct engages correctly.

- Press the instrument panel vent into the installation opening as far as the stop.