Clock: Service and Repair

Radio Frequency Controlled Clock Receiver (J489)

Removing






- Remove the rear bumper cover.

- Remove the bolts - arrows - and the radio frequency controlled clock receiver - item 2 -.

- Disconnect the electrical connector - 1 - from the radio frequency controlled clock receiver.

Installing

• Tightening specifications, refer to => [ Instrument Cluster Radio Frequency Controlled Clock Receiver Overview ] Instrument Cluster Radio Frequency Controlled Clock Receiver Overview.

Install in reverse order of removal, observing the following:

- Install the rear bumper cover.

With Lane Change Assist

If the bumper cover was removed, the lane change assistance control modules must be calibrated again. Refer to => [ Lane Change Assistance, Preparing for Calibration ] Lane Change Assistance, Preparing For Calibration.