Right Engine Mount

Right Engine Mount

• To avoid repeat repairs, do the following if the engine mount is faulty:

• Replace the faulty engine mount and its retaining plate.

• Likewise replace the engine mount on the opposite side, check the retaining plate and replace it if necessary.

Special tools, testers and auxiliary items required

• Engine Support Bridge (10 - 222 A)

• Spindles (10 - 222 A /11)

• Engine Support Supplement Set (T40093)

• Adapter (T40093/6)

Removing






- Install the (10 - 222 A) with one on the left and right strut towers, as shown in the illustration.

- Attach the (10 - 222 A /11) to the left and right engine lifting eyes.

- Lightly tension the engine with spindles.

- Remove the right front wheel.






- Remove the right front wheel housing liner.

- Remove the noise insulation - 1 and 2 -.

- Remove and disconnect the connector - 2 - on the right electrohydraulic engine mount solenoid valve (N145).






- Remove the nut - 1 - and remove the bracket with the wiring harness from the subframe.

- Remove the bolts - 1, 2 and 4 - and move the right engine mount retaining plate - 3 - to the side.






Vehicles with S-Tronic transmission 0B5






- Remove bolt - arrow - on ATF line bracket.

• Ignore - 1 and 2 -.

All Vehicles






- Lift the engine by the right (10 - 222 A /11) - 1 - by dimension - a -.

• Dimension - a - = approximately 20 mm.

- Remove the right engine mount.

Installing

Install in reverse order of removal. Note the following:

• Tightening specifications, refer to => [ Subframe Mount Overview ] Subframe Mount Overview.

• Replace bolts that are tightened to the specification.

Vehicles with S-Tronic Transmission 0B5

- Install ATF lines.

All Vehicles

- Install the front wheel housing liner and noise insulation.

- Install the front wheel.