Brake Pedal, Manual Transmission

Brake Pedal, Manual Transmission

• To remove the brake pedal on vehicles with a manual transmission, the mounting bracket must be removed.



- Remove the mounting bracket, refer to => [ Mounting Bracket, Manual Transmission ] Mounting Bracket, Manual Transmission.

• Remove the brake pedal on the removed mounting bracket.

Special tools, testers and auxiliary items required

• Torque Wrench (V.A.G 1410)

- Remove the bolt - 3 -.






- Remove the retainer - 1 - on the left side and remove the pins - 5 - to the right.






- Remove brake pedal.

• Install the brake pedal on the removed mounting bracket.

If possible, leave the brake pedal stop installed; it could break the mount for the brake lamp sensor if the brake pedal is released too quickly.






• If possible, leave the brake pedal stop - 17 - installed; it could break the mount for the brake lamp sensor - 10 - if the brake pedal is released too quickly.

Be careful not to damage the stop - 17 - on the brake pedal. The brake lamp sensor mount - 10 - could break when the brake pedal is unlocked.

- Slide the right retainer onto the pins.

- Slide the pins from right to left through the axle in the brake pedal.

- Secure the pins with the left retainer - 1 -.






• The pins must be secured with the retainers on both sides.








- Install and tighten the bolt - 3 -.

- Install the mounting bracket, refer to => [ Mounting Bracket, Manual Transmission ] Mounting Bracket, Manual Transmission.