Headrest Cover and Upholstery With Locking Mechanism

Headrest Cover and Upholstery with Locking Mechanism

• It is only possible to replace the cover on the headrest with a leather cover. It is not possible to replace a fabric headrest cover because the cover is filled with foam and also serves as the casing for the upholstery.

• The headrest support is built into the upholstery. Both components are attached to each other and cannot be separated.

Special tools, testers and auxiliary items required

• Trim Removal Wedge (3409)

Removing

• Follow all safety precautions when working on pyrotechnic components. Refer to => [ Restraint System Components ] Description and Operation.

• Before handling pyrotechnical components (for example, disconnecting the connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

- Remove headrests:

• Refer to => [ Headrests with Locking Mechanism ] Headrests With Locking Mechanism.

• Refer to => [ Power Headrests ] Power Headrests.

- Open the side locks - arrows - on the cover - 1 -.






- Insert the (3409) in direction of - arrow A - between the cover zipper - 1 -.






- Bend the lower U-channel - 3 - in the direction of - arrow B -.

- Pull the upper side of the cover with the flat channel - 2 - out of the U-channel.

- Open the zipper by inserting the (3409) between the zipper and the cover.






- Bend the lower U-channel - 1 - in the direction of - arrow A -.

- Pull the upper side of the cover with the flat channel - 2 - out of the U-channel.

• The cover must be completely open to remove the upholstery.

- Remove the padding - 1 - from the cover - 2 -.






Installing

- Insert cushion - 1 - into cover - 2 - and make sure it fits properly.

- Insert headrest mount in upholstery with cover.

- Closes the main zipper by moving the upper cover flat channel - 1 - - 2 -.






- Slide the edge of the fabric edge with the flat channel into the U-channel - 5 -.

- Closing the side locks is similar to the closing the main lock.

- After closing the main zipper and the side zippers with a needle or other pointed object, line up the cover and the profiles.

- Ensure the cover sits on the upholstery - 3 - without any wrinkles and without seam markings.

Further installation is performed in the reverse order of removal.