Left Convertible Top Compartment Enclosure Motor

Left Convertible Top Compartment Enclosure Motor

• The convertible top compartment enclosure motor is installed on the left side only.

Removing






• Bracket for the convertible top compartment enclosure removed.

- Unclip the connector - arrow -.

- Remove the screws - 1 through 6 - and remove the cover.

- Remove the circlips - arrows - and remove the damper - 1 -.






- Remove the screws - 1 through 3 - and remove the cover.






- Remove the convertible top compartment enclosure motor. When doing this the tension on the drive wheel spring will be released.

• Depending on the date of manufacture, the motor is attached in different ways.






- Remove the motor according to the version:

• Remove the bolts - 1 - and - 2 -.

• Loosen the motor.

• Release the clip - 3 -.

Installing






- Tighten the screws - 3 - to attach the motor to the bracket.

- Install the spring - 2 - and drive wheel axle - 1 - in the bracket.

• The spring fits into the groove on the bracket.

- Mount the drive wheel onto the axle. The end of the spring must fit into the opening in the drive wheel.






• Press the drive wheel onto the axle just far enough so that the teeth still do not mesh with the teeth on the motor.

- Turn the drive wheel 360° three times clockwise - arrow A - to pretension the spring.






- Push the drive wheel all the way down - arrow B -.

• The teeth are now engaged.

- Hold the drive wheel in this position and secure it with tape - arrows -.






- Make sure the inner release lever - 3 - is installed correctly:






• The spring - 2 - must engage on the bracket.

• The tab - 1 - on the release lever must be positioned as shown in the illustration (below the release lever).

- Push the outer lever - 1 - in - direction of arrow A -.






- Push the lever - 2 - in direction of - arrow B -.

- Secure both levers in this position with tape - arrows -.

- Install the motor and mount into the bracket and tighten the screws - 1, 2 and 3 -.






- Remove the tape.

Further installation is performed in reverse sequence of removal, but observe the following:

- Guide the wire through the slot in the bracket.