Adjusting

Adjusting

Special tools, testers and auxiliary items required

• Adjustment Gauge (3371)

Procedure






• Gap dimensions, refer to => [ Gap Dimensions ] Gap Dimensions.

• Tightening specifications, refer to => [ Adjusting Buffer, Locking Motor and End Plate Overview ] Adjusting Buffer, Locking Motor and End Plate Overview.

Side and length adjustment at the hinge

- Loosen the left and right nuts - 2 - on the hinge - 1 -.

- Adjust the rear lid - 3 - from side to side and from back to rear.

- Tighten the bolts.

Height adjustment at the hinge

- Loosen the left and right nuts - 4 - on the hinge - 1 -.

- Adjust the height of the rear lid - 3 -.

- Tighten the bolts.

Adjusting striker pin height






• Tightening specifications, refer to => [ Rear Lid Hinge, Gas-Filled Strut, Stop and Rear Lid Overview ] Rear Lid Hinge, Gas-Filled Strut, Stop and Rear Lid Overview.

- Remove the rear lid end piece trim piece..

- Loosen the nuts - 1 - and - 3 - just enough so that it is possible to move the - 2 - striker pin.

• During the closing test, the lid must fall from the balance position into the lid lock and engage completely.

- Tighten the nuts - 1 - and - 3 -.

Adjusting the adjusting buffer sideways






- Turn the adjusting buffer - 2 - - arrows - until the closed rear lid makes contact.

• The rear lid must lie on the lid side stop with light tension.

• Check if the rear lid sits without tension and closes by pressing or pulling at the side edges of the rear lid.

- Repeat the adjustment if necessary.

Adjusting the center adjusting buffer






- Turn the adjusting buffer - 2 - using a hex socket wrench - 1 - - arrows - until the closed lid makes contact.

• The rear lid must lie on the lid side stop with light tension.

• Check if the rear lid sits without tension and closes by pressing or pulling at the side edges of the rear lid.

- Repeat the adjustment if necessary.