Rollover Bar Guide

Rollover Bar Guide

• Removal and installation are same for right and left.

Removing

Follow the safety precautions for the rollover protection. Refer to => [ Rollover Protection Safety Precautions ] Rollover Protection Safety Precautions.

- Perform an output diagnostic test under "Guided Functions". Refer to Vehicle diagnostic tester.

• The rollover bars are extended.

- Disconnect the Ground (GND) cable on the battery.

- Release the hooks - 1 and 2 - with a small screwdriver and remove the guide - 3 - downward - arrow -.






Installing

Follow the safety precautions for the rollover protection. Refer to => [ Rollover Protection Safety Precautions ] Rollover Protection Safety Precautions.

Installation is reverse of removal, but note the following:

- Press on the rollover protection guide back on until it engages audibly.

- Return a deployed rollover protection back into it stored position. Refer to => [ Deployed Rollover Protection, Returning to Stored Position ] Deployed Rollover Protection, Returning to Stored Position.

Make sure no one is standing near the rollover protection when reconnecting the battery. Stand at least 1 meter away.

- Connect the Ground (GND) cable on the battery.

- ALWAYS perform an output diagnostic test under "Guided Functions" after repairing the rollover protection and only after all work procedures are completed (also if a new rollover protection was installed). Refer to vehicle diagnostic tester.