Anti-roll Bar Trim

Anti-Roll Bar Trim

• Removal and installation are same for right and left.

Special tools, testers and auxiliary items required

• Trim Removal Wedge (3409)

Removing






Follow the safety precautions for the rollover protection. Refer to => [ Rollover Protection Safety Precautions ] Rollover Protection Safety Precautions.

- Open the convertible top until the displayed position of the top and the convertible top compartment cover is reached.

- Support the convertible top with a suitable wood stick.

- Disconnect the Ground (GND) cable on the battery.

- Unhook the hooks - 1 - on the rollover protection trim through the openings in the aluminum mount - arrow A -.






- At the same time push the trim with the trim removal wedge (3409) upward - arrow B - to prevent the hooks from getting hooked in again.

- Do this to all 4 hooks and then remove the trim.

Installing

Follow the safety precautions for the rollover protection. Refer to => [ Rollover Protection Safety Precautions ] Rollover Protection Safety Precautions.

Installation is reverse of removal, but note the following:

- Press the rollover protection trim back on until it engages audibly.

Make sure no one is standing near the rollover protection when reconnecting the battery. Stand at least 1 meter away.

- Connect the GND cable on the battery.

- ALWAYS perform an output diagnostic test under "Guided Functions" after repairing the rollover protection and only after all work procedures are completed (also if a new rollover protection was installed). Refer to the vehicle diagnostic tester.