Rear Cross Panel Trim

Rear Cross Panel Trim

Special tools, testers and auxiliary items required

• Trim Removal Wedge (3409)

Removing






- Remove the rear luggage compartment floor covering. Refer to => [ Rear Luggage Compartment Floor Covering ] Rear Luggage Compartment Floor Covering.

- Remove the rear lid seal lip near the rear lid end panel trim panel.

- Unclip rear cross panel trim - 2 - upward vertically using a (3409) - arrows -.

Installing

Install in reverse order of removal. Note the following:

• If the trim clamps remain in the body mounting points, remove them and insert them in the trim.

• Check clamps for damage or deformation, replace if necessary.

- Guide the left and right rear cross panel trim retaining tabs in the openings on the luggage compartment side trim - 1 -.

- Insert the rear cross panel trim so that the left and right tabs engage in pins - 3 -.

- Push on the rear cross panel trim until it engages audibly and stretch the lip of the rear lid seal over the rear cross panel trim.