Servotronic Solenoid Valve (N119)

Servotronic Solenoid Valve (N119)

Special tools, testers and auxiliary items required

• Torque Wrench (V.A.G 1783)

• Steering gear grease

Removing

Request values with vehicle diagnostic tester - item 17 - => [ (Item 17) ] Overhaul.

- With vehicles with air suspension, place vehicle on hoist. Refer to => [ Positioning Vehicle on Hoist and Wheels ] Positioning Vehicle on Hoist and Wheels.

- Only remove front noise insulation - 1 -.






- Always clean steering gear - 6 - in servotronic solenoid valve - 3 - area.






- Make sure that no dirt enters steering gear - 6 -.

- Separate connector - 8 -.

- Make sure no dirt enters the connector - 8 -.

- Remove bolts - 1 - and - 2 -.

- Remove servotronic solenoid valve - 3 - from steering gear - 6 -.

- Remove screen - 7 - from steering gear - 6 -, clean steering gear if necessary.

Installing

Install in reverse order of removal. Note the following:

- Insert a new screen - 7 -.






- Lightly coat gasket - 4 and 5 - with steering gear grease and insert. Place servotronic solenoid valve - 3 - in steering gear - 6 - as far as stop. Do not tilt servotronic solenoid valve when doing so.

• Always follow screw tightening sequence.

- Tighten bolts - 1 and 2 - as follows:

1. Tighten bolt - 1 - to 0.5 Nm.

2. Tighten bolt - 2 - to 1.5 Nm.

3. Tighten bolt - 1 - to 3.0 Nm.

4. Tighten bolt - 2 - to 3.0 Nm.


- On vehicles with air suspension, position vehicle on wheels. Refer to => [ Positioning Vehicle on Hoist and Wheels ] Positioning Vehicle on Hoist and Wheels.