Upper Coolant Pipe

Upper Coolant Pipe

Removing






• When installing, bring all cable ties back to same positions.

- Drain the coolant. Refer to => [ Coolant, Draining and Filling ] Service and Repair.

- Remove the right lower section of the intake manifold.

- Remove the nuts - arrows - and the high pressure line protective plate - 1 -.






- Remove the front secondary air hose - arrow - from its bracket and disconnect it; to do this press the release buttons.






- Remove the threaded connection - 1 -.






- Loosen the union nuts - 2 and 3 - by counter holding at the connections.

- Remove the bolts - arrows - on the retaining plates and the high pressure line.

• Lay a cloth below the coolant pipe to catch escaping coolant.






- Open the clamp - 2 - and remove the coolant hose from the coolant pipe.

- Remove the bolt - 1 - and remove the coolant pipe back out of the cylinder block - arrow -.

Installing

Install in reverse order, paying attention to the following:

• Tightening specification, refer to => [ Coolant Pipes Overview ] Coolant Pipes Overview.

• Replace the O-rings.

- Clean and smooth the O-ring sealing surface.

- Coat the O-ring with coolant and slide it onto the coolant pipe.

- Connect the coolant hose to the coupling. Refer to => [ Connect the Coolant Hose to the Coupling ] Radiator Overview.

- Install the high pressure line and the right intake manifold lower section.

- Fill the coolant system => [ Filling ] Service and Repair.