Right Coolant Pipe on Transmission

Right Coolant Pipe on Transmission

Special tools, testers and auxiliary items required

• Hose Clip Pliers (VAS 6340)

• Hose Clip Pliers (VAS 6362)

Removing






• When installing, bring all cable ties back to same positions.

- Drain the coolant. Refer to => [ Coolant, Draining and Filling ] Service and Repair.

- Remove the right front wheel.

- Remove the generator.

- Remove the vacuum hose - 1 - from the air guide pipe connection.






- Loosen the clamps - arrows - and remove the air guide pipe.

- Remove the bolt - 1 - from the right coolant pipe on the transmission.






- Loosen the hose clamp - 2 -.

- Remove the right engine mount. Refer to => [ Engine Mount ] Engine Mount.

- Disconnect the connector - 3 -.






- Press the release buttons and remove the secondary air hoses - 1 -.

- Remove the nuts - 2 - and loosen the nut - 5 -.

- Remove the secondary air pump motor (V101) and bracket.

• Ignore - 4 -.

- Remove the bolt - 2 - for the ground cable on the right longitudinal member.






• Ignore - 1 -.

- Remove the bolts - arrows - and remove the right engine support - 1 -.






- Disconnect the connector - 4 -.






- Remove the nuts - 1 and 3 - and free up the B+ wire on the starter.

• Ignore - 2 and 5 -.

- Remove the bolts - 1 - from the right coolant pipe on the transmission.






- Remove the bolt - 2 - from the ATF pipe.

- Free up the wiring harness and remove the right coolant pipe from the transmission

• Ignore - 3 -.

Installing

Install in reverse order, paying attention to the following:

• For the correct tightening specifications, refer to => [ Coolant Pipes Overview ] Coolant Pipes Overview.

• The hose connections as well as the air guide pipes and hoses must be free of oil and grease before installing.

• Secure all hose connections with hose clamps of the same type as those equipped by the factory. Refer to the Parts Catalog.

• To mount the air guide hoses on their connectors securely, spray the bolts on the used clamps with rust remover before installing.

- Install ATF lines.

- Install the starter.

- Install the right engine support. Refer to => [ Subframe Overview ] Subframe Overview.

- Install the right engine mount. Refer to => [ Engine Mount ] Engine Mount.

- Install the Secondary Air Injection (AIR) pump motor (V101). Refer to => [ Secondary Air Injection (AIR) Pump Motor (V101) ] Service and Repair.

- Install the generator.

- Install the right front wheel.

- Fill the coolant system => [ Filling ] Service and Repair.