Fog/Driving Lamp: Adjustments

Fog Lamps, Adjusting

Checking and Adjusting Conditions

• Tire pressure OK.

• Headlamp lenses must be clean and dry.

• Headlamp lenses must not be damaged.

• Headlamp reflectors and bulbs OK

With Steel Suspension:

• Vehicle load must be created.

Vehicle load on driver's seat in otherwise unloaded vehicle (curb weight).

• One person or 75 kg.

With Air Suspension:

• The compressed air reservoir must be filled. Start the engine and let it run at idle for approximately 2 minutes.

All Vehicles

• Roll the vehicle several yards or move it back and forth several times to seat the springs.

• The parking brake must not be engaged so the vehicle is not under tension.

• Vehicle and headlamp adjusting unit must be on a level surface.

• The headlamp adjusting unit must be aligned to the vehicle. Refer to the Headlamp adjusting unit instructions.

• The inclination dimension is set on the headlamp adjusting unit. Refer to the Headlamp adjusting unit operating instructions.

Procedure

- The vehicles must be standing on a flat surface.

- Turn the headlamp switch to low beam - not Auto.

- Pull the headlamp switch to fog lamp.






Vehicles Without S Line Equipment:

- Remove air intake grille - 1 - in lower part of bumper cover - arrows -.

Vehicles With S Line Equipment:






- Remove the air inlet grille - 1 - in the lower part of the bumper cover in the sequenced shown - arrow A - and - arrow B -.

All Vehicles






- To adjust headlamp range, turn adjusting screw - arrow -.

• Angle dimension: 20 cm (conforms to 2%).

• Side adjustment is not intended.