Oil Pressure Regulation Valve (N428)

Oil Pressure Regulation Valve (N428)

Removing






- Remove the left front wheel housing liner.

- Remove the left engine mount. Refer to => [ Engine Mount ] Engine Mount.

- Remove the bolts - arrows - and the left engine support.






- Disconnect the connector - 1 -.






- Remove the bolt - 3 - and then remove the oil pressure regulation valve - 4 -.

Installing

Install in reverse order, paying attention to the following:

• Tightening specification, refer to => Oil Filter Housing Overview.

• Replace O-ring - 2 -.

- Install the left engine support. Refer to => [ Subframe Overview ] Subframe Overview.

- Install the left engine mount. Refer to => [ Engine Mount ] Engine Mount.

- Install the left front wheel housing liner.