Left Cylinder Head Cover

Left Cylinder Head Cover

Removing






- Remove ignition coils.








Risk of violating emissions legislation.

• Do not open the hose connection - arrow -.

- Remove the bolts in the following sequence - 12 to 1 - and lay the left cylinder head aside with the crankcase ventilation hose - arrow - connected.

Installing

Install in reverse order, paying attention to the following:

• For the correct tightening specifications, refer to => [ Left Cylinder Head Cover, Tightening Specifications and Sequence ] Cylinder Head Overview.

• Replace the O-ring.

• Replace the cylinder head seal if it is damaged.

• Replace the cylinder head cover bolts when replacing the damaged seal.

- Clean the sealing surfaces; they must be free of oil and grease.

- Tighten the left cylinder head cover bolts. Refer to => [ Left Cylinder Head Cover, Tightening Specifications and Sequence ] Cylinder Head Overview.

- Install ignition coils.