Bonded Rubber Bushing In Transmission Carrier, Replacing

Bonded Rubber Bushing in Transmission Carrier, Replacing

Special tools, testers and auxiliary items required

• Pressure plate (VW 402)

• Punch (VW 412)

• Thrust piece (VW 432)

• Base block (VW 441)

• Tube (3296)

• Alignment fixture (T10214)

- Remove transmission carrier. Refer to => [ Transmission Carrier and Console ] Transmission Carrier and Console.

- Press out bonded rubber bushing.

- Connect new bonded rubber bushing with pressure piece (T10214/3).





- Press new bonded rubber bushing - A - with pressure piece (T10214/3) into the guide sleeve (T10214/2), until the pressure piece (T10214/3) is flush with the guide sleeve (T10214/2).





- Align bonded rubber bushing to the transmission carrier, using the assembly tool (T10214).

- For this, align bolts - A - and/or notch - arrow - on pressure piece (T10214/3) centrally to the holes in the transmission carrier.





The spacing "x" must be the same.

- Now, press the bonded rubber bushing into the transmission carrier, until the guide sleeve (T10214/2) can be turned by hand - arrows -.





Do not press the bonded rubber bushing any deeper into the transmission carrier than the height of the tube (3296), if necessary press further using base block (VW 441) up to stop.

- Install transmission carrier. Refer to => [ Transmission Carrier and Console ] Transmission Carrier and Console.