Selector Lever Handle

Selector Lever Handle

Special tools, testers and auxiliary items required

• Hose Clip Pliers (V.A.G 1275)

Removing






- Move the selector lever into "N".

• Both the selector lever handle and the selector lever boot are removed.

- Remove the frame for the selector lever boot - 1 - - arrows -.

- Secure the locking button in its pulled-out position with a cable tie - arrow -, as illustrated.






- Fold the selector lever boot - B - upward and over the selector lever handle - C -.






- Open the plastic sleeve - A - and remove both the selector lever handle and the selector lever boot without touching the locking button.

Installing






• In order to install the selector lever handle, the locking button must be pulled out all the way and secured either with a cable tie - arrow - or with the assembly tool supplied with a new handle.

• If the lock button was not secured, do not pull it out from the handle using mechanical aids. Mount the compressed air gun to the bottom of the handle and then push the locking button out with compressed air.

- Install the selector lever handle all the way onto the selector lever - make sure the locking button faces the driver.

• When doing this, the handle must engage into the ring groove of the selector lever.

- Remove cable tie or assembly aid, lock button mechanism engages in vertical groove on the selector lever.

- If necessary, press lock button back into selector lever handle.

- Clamp the handle - C - to the selector lever, using a new plastic sleeve - A -. Use (V.A.G 1275).






- Install the selector lever boot frame - B - in the center console.