Front Seat Belt Height Adjuster

Front Seat Belt Height Adjuster

Remove Seat Belt Height Adjuster

- Press belt height adjuster button and bring height adjuster slide => [ (Item 5) Slide ] Front Seat Belt Height Adjuster Assembly Overview into lowest position.

- Remove the B-pillar trim. Refer to => [ B-Pillar Trim Overview ] B-Pillar Trim Overview.

- Lay aside the B-pillar trim with the belt webbing threaded through.

- Remove the bolt - 3 -.






- Remove belt relay - 2 - with belt webbing - 1 -.

- Remove the bolt - 5 -.

- Pull seat belt height adjuster - 4 - up and out of the B-pillar.

Install Seat Belt Height Adjuster

• Replacement seat belt height adjusters are always in the bottom-most locking position (assembly position).

• If removed seat belt height adjusters are reinstalled, these should be placed in the bottom-most position (assembly position).

- Engage seat belt height adjuster - 4 - in the B-pillar.






- Install screw - 5 - and tighten it to the specification.

- Install the safety belt relay - 2 - and tighten screw - 3 - to the tightening specification.

• The belt height adjuster button must not be pressed when installing the B-pillar trim with the slide => [ (Item 5) Slide ] Front Seat Belt Height Adjuster Assembly Overview.

• Ensure that the seat belt height adjuster is in the bottom-most position.

- Ensure that sliding piece mount - 3 - of B-pillar trim - 1 - engages on retaining pins - 4 - of the seat belt height adjuster.






- Install B-pillar trim - 1 -, refer to => [ B-Pillar Trim Overview ] B-Pillar Trim Overview, noting belt webbing - 2 -.

Seat Belt Height Adjuster As Replacement Part

- After installing the B-pillar trim, forcefully press the slide => [ (Item 5) Slide ] Front Seat Belt Height Adjuster Assembly Overview upward (approx. 60 Nm).

This removes the seat belt height adjuster assembly anchorage.

Procedure for all Seat Belt Height Adjusters

- Check function.

When checking function, following conditions must be fulfilled:

• The seat belt height adjuster must audibly engage all 5 possible positions (and in the top-most position too).

• Belt height adjuster button must return to upper position by itself after being pressed.

• Belt relay must swing into vertical position or carrier direction by itself after tightening screw.

If any functions did not work, the seat belt height adjuster assembly must be checked; the height adjuster may need to be replaced.

For the correct tightening specification refer to => [ Front Seat Belt Height Adjuster Assembly Overview ] Front Seat Belt Height Adjuster Assembly Overview