Belt Latch Anchorage Point

Belt Latch Anchorage Point

Removing






Follow all safety precautions when working on pyrotechnic components. Refer to => [ Restraint System Components, Safety Precautions and General Information ] Restraint System Components, Safety Precautions and General Information.

- Remove the front seat.

• Manual seat, refer to => [ Driver Seat Assembly Overview ] Driver Seat Assembly Overview

• Memory seat, power seat and Comfort seat, refer to => [ Driver Seat Assembly Overview ] Driver Seat Assembly Overview.

- Remove belt buckle - 1 - screw - 4 -.

- Vehicles with seat belt fasten sensor: Press the tabs - 2 - and disconnect the connector.

Installation

Install in reverse order of removal. Note the following:

Follow all safety precautions when working on pyrotechnic components. Refer to => [ Restraint System Components, Safety Precautions and General Information ] Restraint System Components, Safety Precautions and General Information.

- Vehicles with seat belt fasten sensor: make sure the wire is connected at position - 3 -.

Tightening Specifications