Belt Anchor

Belt Anchor

• Removal and installation is described for the right side of the vehicle. Removing and installing on the left side is identical.

Removing






- Position seat as far forward as possible using fore/aft adjustment.

- Remove assembly cover - 1 -.

• Spring - 4 - can be bent if removed improperly. The three-point seat belt must be replaced if the spring is bent.

• Move the spring - 4 - just far enough until it is possible to unlock the tab on the spring.

- Release the spring catches - 4 - by inserting a small screwdriver in the opening in the spring - arrow -.

- Move the belt anchor - 2 - down and detach at the pin - 3 -.

- Pull belt anchor - 1 - outward from T-pin on seat - 2 -.






- Guide belt anchor - 1 - through belt guide on seat frame - 3 -.

• It is not necessary to remove backrest trim - 4 - to perform this work on vehicles with electric seat adjusters.

Installation






Install in reverse order of removal. Note the following:

• Spring - 2 - can be bent if removed improperly. The three-point seat belt must be replaced if the spring is bent.

• Move the spring - 2 - just far enough until it is possible to unlock the tab on the spring.

- Guide the belt end fitting through the seat belt guide on the seat.

- Connect the belt anchor - 3 - to the bolt - 1 - - arrow A -and pull it up - arrow B -, until the spring catches - 2 - audibly lock on the bolt heat.

Tug on seat belt to ensure that seat belt is securely locked to seat.