Driver Side and Passenger Side Rear Side Airbag Igniter N201 and N202

Driver Side and Passenger Side Rear Side Airbag Igniter N201 and N202

Special tools, testers and auxiliary items required

• Vehicle Diagnosis Tester

Removing

• Follow all safety precautions when working on pyrotechnic components. Refer to => [ Restraint System Components, Safety Precautions and General Information ] Restraint System Components, Safety Precautions and General Information.

• Follow the additional safety precautions when working with the side airbag. Refer to => [ Side Airbag, Additional Safety Precautions ] Side Airbag, Additional Safety Precautions.

• Follow all regulations when disposing of pyrotechnic components. Refer to => [ Airbag, Belt Tensioner and Battery Cut-Out Units, Storage, Transporting and Disposal ] Airbag, Belt Tensioner and Battery Cut-Out Units, Storage, Transporting and Disposal.

- Turn on the ignition.

- Turn on the ignition and disconnect the ground cable from the battery.

- Remove left or right 2nd row seat.

• Seat beach (two-thirds bench), refer to => [ 2nd Row, 3-Seater Assembly Overview ] 2nd Row, 3-Seater Assembly Overview

• Individual seat, refer to => [ 2nd Row, 2-Seater Assembly Overview ] 2nd Row, 2-Seater Assembly Overview

- Remove padding from backrest until screw - 1 - is reached.

• Individual seat, refer to => [ Backrest Cover and Upholstery ] Backrest Cover and Upholstery

• Seat beach (two-thirds bench), refer to => [ Backrest Cover and Upholstery ] Backrest Cover and Upholstery

- Remove the bolt - 1 - and remove the rear driver/passenger side airbag hook - 2 - out of the rear driver/passenger side airbag - 4 - - 3 - in the backrest.






- Guide airbag cable - 5 - and remove the side airbag from the backrest frame.

Installation

• Follow all safety precautions when working on pyrotechnic components. Refer to => [ Restraint System Components, Safety Precautions and General Information ] Restraint System Components, Safety Precautions and General Information.

• Follow the additional safety precautions when working with the side airbag. Refer to => [ Side Airbag, Additional Safety Precautions ] Side Airbag, Additional Safety Precautions.

Install in reverse order of removal. Note the following:

• Make sure the connectors are installed all the way in and are secure.

• Make sure the wires do not get caught.

- Replace screw - 1 -.






- Tighten new screw - 1 - to the specification.

- Install left or right 2nd row seat.

• Seat beach (two-thirds bench), refer to => [ 2nd Row, 3-Seater Assembly Overview ] 2nd Row, 3-Seater Assembly Overview

• Individual seat, refer to => [ 2nd Row, 2-Seater Assembly Overview ] 2nd Row, 2-Seater Assembly Overview

Ignition must be on when connecting battery. If pyrotechnic components (for example, airbag, belt tensioner) are not repaired correctly, they may deploy unintentionally after connecting battery. Maintain personal safety when connecting the battery by staying out of airbag deployment areas, keeping a distance from belt tensioners/seat belts and ensuring no other people are in the vehicle interior at the moment when the battery is connected.

- Switch on ignition.

- Connect the battery ground cable with the ignition turned on.

- If the airbag indicator lamp (K75) indicates a fault after installation, the DTC memory must be checked, deleted and checked again. Refer to vehicle diagnostic tester.

Tightening Specifications






* Replace screw