Cooler Compressor Control Module

Cooler Compressor Control Module

Removing






- Remove the cooler. Refer to => [ Cooler J698 ] Cooler J698.

- Disconnect the electrical connectors - 1 through 7 -.

- Install the safety screw - 3 - all the way.






- Remove the control module - 1 - from the bracket by moving it - arrow A -.

- Remove the connector - 2 - from the compressor - arrows B -.

Installing

Installation is reverse of removal, noting the following:

- Unscrew the retaining screw until it is flush with the outer side of the control module housing.

- Install the cooler. Refer to => [ Installing ] Cooler J698.

Tightening specifications, refer to => [ Cooler Overview ] Cooler Overview.