Front Backrest

Front Backrest

Special tools, testers and auxiliary items required

• Engine and transmission holder (VAS 6095)






• Fixture for seat repair (VAS 6136)






• The removal and installation procedure describes a driver seat. The procedure for the front passenger seat is identical.

Removing

Follow all safety precautions when working on pyrotechnic components. Refer to => [ Restraint System Components, Safety Precautions and General Information ] Restraint System Components, Safety Precautions and General Information.

- Remove the front seat. Refer to => [ Driver Seat Assembly Overview ] Driver Seat Assembly Overview.

- Mount the fixture for seat repair (VAS 6136) on the engine and transmission holder (VAS 6095).

- Attach the seat to the fixture for seat repair (VAS 6136).

- Remove trim. Refer to => [ Trim ] Trim.

- Remove tunnel side trim panel. Refer to => [ Tunnel Side Trim ] Tunnel Side Trim.

- Create photos or sketches of wire securing and routing.






- Disconnect connectors and remove wiring - 2 - from seat pan spring mat - 6 -.

- Disengage retaining strip - 2 - from lower seat frame - 1 -.






- Disengage tabs - 5 - (quantity: 4) from seat pan spring mat - 6 -.






- Remove the bolts - 3 -.

- Tip backrest - 1 - forward onto seat pan - 6 -.

- Push padding to side and carefully pull wiring harness - 2 - from seat pan - 6 -.

- Remove backrest - 1 -.

Installation

Follow all safety precautions when working on pyrotechnic components. Refer to => [ Restraint System Components, Safety Precautions and General Information ] Restraint System Components, Safety Precautions and General Information.

Install in reverse order of removal. Note the following:

- Cut threads in backrest frame before installing new screws - 3 - (quantity: 4).






- Replace screws - 3 - (quantity: 4) after each removal.

Before handling airbag units (for example, when disconnecting the harness connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

- Route and secure wiring according to photos or sketches that were made.

- Ensure all connectors are engaged correctly.

• Make sure the connectors are installed all the way in and are secure.

• Make sure the wires do not get caught.

Ignition must be on when connecting battery. If pyrotechnic components (for example, airbag, belt tensioner) are not repaired correctly, they may deploy unintentionally after connecting battery. Maintain personal safety when connecting the battery by staying out of airbag deployment areas, keeping a distance from belt tensioners/seat belts and ensuring no other people are in the vehicle interior at the moment when the battery is connected.

- Switch on ignition.

- Connect the battery ground cable with the ignition turned on.

- If the airbag indicator lamp (K75) indicates a fault after installation, the DTC memory must be checked, deleted and checked again. Refer to Vehicle diagnostic tester.

For the correct tightening specifications; refer to => [ Front backrest ] Front Backrest.