Suspension Control ( Automatic - Electronic ): Testing and Inspection

Self-Leveling Suspension Control Position, Programming with Vehicle Diagnostic Tester

• Adapting control position and checking headlamp basic setting is necessary if:

• The lower transverse link has been removed and reinstalled or replaced.

• The subframe was replaced.

• Installation work has been performed on the level control system sensor.

• The level control system sensor has been replaced.

• The level control system sensor coupling rod threaded connection was loosened at the lower transverse link.

• The level control system control module (J197) was replaced.

Requirements

• The vehicle must be standing on an even surface.

• The vehicle may not be loaded.

- Connect the vehicle diagnostic tester and select address "34 - level control system control module" in "Guided Functions".

Then

- Select "J197 - reprogram control position" and follow the instructions on the screen.

• If the control position was reprogrammed and if the vehicle has lane assist, then it will then be necessary to calibrate the camera control module (J852). Refer to => [ Camera Control Module (J852), Lane Assist, Calibrating ] Testing and Inspection.

• Perform a basic setting on the headlamp.