Track Control Arm Bonded Rubber Bushing, Wheel Bearing Housing Side

Track Control Arm Bonded Rubber Bushing, Wheel Bearing Housing Side

Special tools, testers and auxiliary items required

• Thrust Plate (VW 402)

• Punch (VW 412)

• Tube 42 mm Dia. (VW 516)

• Tube (3296)

• Assembly paste (G 052 109 A2)

• The control arm is removed. Refer to => [ Track Control Arm ] Track Control Arm.

• Hold track control arm firmly when removing and installing the bonded rubber bushing.

Pressing Out the Bonded Rubber Bushing






- Mark the press-in depth on the bonded rubber bushing - 1 - - arrow -.

• Use a waterproof felt-tip pen.

- Install the special tools as shown in the illustration.

- Remove the bonded rubber bushing - 1 - from the control arm - 2 -.

Pressing In the Bonded Rubber Bushing






- Transfer the installation depth marking from the old bonded rubber bushing to the new one.

- Coat the bonded rubber bushing lightly with assembly paste (G 052 109 A2).

- Install the bonded rubber bushing - 1 - into the control arm - 2 -.

- Install the special tools as shown in the illustration.

• When installing, make sure the bonded rubber bushing does not tilt.

- Install the bonded rubber bushing - 1 - into the control arm - 2 -.

- Note the installation depth marking when installing - arrow -.

- Check the press-in depth of the bonded rubber bushing - 1 - inside the control arm - 2 -.






Dimensions - a and b - must be identical.

- If the dimensions - a and b - are different, adjust the bonded rubber bushing - 1 -.

- Install the control arm. Refer to => [ Track Control Arm ] Track Control Arm.