Starter

Starter

Observe notes on contact corrosion, refer to => [ Contact Corrosion ] Contact Corrosion.

Removal






- Turn off the ignition and disconnect the ground cable from the battery. Refer to => [ Battery, Disconnecting and Connecting ] Service and Repair.

- Remove the plenum chamber bulkhead.

- Remove the bolts - arrow -.

- Remove the engine mount.






- Remove the nut - 1 - and free up the ground wire on the engine support.

- Remove the bolts - arrows - and the right engine support.

- Disconnect the electrical connector - 3 - by sliding the retainer back and pressing the release down.






- Remove the nut - 4 - and disconnect the B+ wire - 2 - from the solenoid switch.

- Remove the bolt - 5 - and the starter - 1 -.

Installation

• Tightening specifications, refer to => [ Starter Overview ] Service and Repair.

Install in reverse order of removal, observing the following:

- Install the engine support and the engine mount.

- Install the plenum chamber bulkhead.

- Connect the battery. Refer to => [ Connecting ] Service and Repair.