46-Pin Connector Mount, CAN Cut-Off Connector

46-Pin Connector Mount, CAN Cut-Off Connector

Removal






- Remove the connector station from the left A-pillar. Refer to => [ Connector Station, Left A-Pillar ] Connector Station, Left A-Pillar.

- Slide the locking lever - 2 - into the "open" position - arrow -.

- Press the release - 1 - and push the mount - 3 - toward the rear.

Installation






Install in reverse order of removal. Note the following:

- Slide the locking lever - 1 - on the mount into the "closed" position.

• Both markings - arrows - must align.

- Install the connector station on the left A-pillar. Refer to => [ Connector Station, Left A-Pillar ] Connector Station, Left A-Pillar.