Socket Illumination Bulb, 12 V Socket 4

Socket Illumination Bulb, 12 V Socket 4

Special tools, testers and auxiliary items required

• Release Tool (T40148)

Removal






- Remove the mount for the cigarette lighter and the socket.

- The release tabs - 2 - on the release tool (T40148) must engage in the openings in the 12V socket - 3 - - arrow - and the threaded pin - 1 - must slide down as far as the stop.

- Open the cover - 3 - for the 12 V socket.






- Open the cover - 4 - on the 12 V socket and hold it in this position.

- Slide the (T40148) as far as the stop into the 12V socket - 1 -.

- Rotate the thumb-wheel - 2 - on the (T40148) clockwise as far as the stop.

• The piston - 2 - is pulled upward and the release tabs - 1 - on the (T40148) spread - arrows -.






- Remove the 12 V socket from the illumination ring with bulb using the (T40148).

- Open the clips - arrows -.






- Remove the 12 V socket and illumination ring - 1 - from the mount - 2 -.

- Guide the wire through the mount.

Installation






Install in reverse order of removal, observing the following:

- Remove the support - 1 - on the (T40148).

- Slide the piston down and hold it in place.

- Rotate the thumb-wheel - 4 - on the (T40148) counterclockwise - arrow -. This loosens the release tabs - 2 - on the 12V socket- 3 - so the (T40148) can be removed.

- Install the mount for the cigarette lighter and the socket.