Left Footwell Vent Temperature Sensor (G261)

Left Footwell Vent Temperature Sensor (G261)

Removal






- Remove the driver side instrument panel cover.

- Turn the vent temperature sensor - 2 - counterclockwise and pull it out of the mount.

- Disconnect the electrical harness connector - 1 -.

Installation

Installation is done in reverse order, observe the following:

- Replace a damaged or defective sealing ring - 3 -.

- Install the instrument panel cover on the driver side.

After completion of the repair work, perform the following work on the control head using the Vehicle Diagnostic Tester in the "Guided Fault Finding" function:

- Read out the event memory and erase any displayed entries.