Oil Pressure Regulation Valve (N428)

Oil Pressure Regulation Valve (N428)

Special tools, testers and auxiliary items required

• Used Oil Collecting and Extracting Device (V.A.G 1782)

Removing

- Remove the front noise insulation - 1 -.






- Place the (V.A.G 1782) under the engine.






- Remove the bolts - arrows - and lay aside the oil cooler with the coolant hoses - 1 - and - 2 - connected.

- Disconnect the connector - 1 -.






- Remove the bolt - 3 - and the oil pressure regulation valve - 4 -.

Installing

Install in reverse order of removal. Note the following:

• Replace O-ring - 2 -.

- Tighten the bolt on the oil pressure regulation valve. Service and Repair

- Install A/C compressor.

- Install the ribbed belt. Refer to => [ Ribbed Belt ] Ribbed Belt.

- Install the oil cooler. Refer to => [ Engine Oil Cooler ] Service and Repair.

- Install the noise insulation.