Harmonic Balancer - Crankshaft Pulley: Service and Repair

Vibration Damper

Special tools, testers and auxiliary items required

• Retainer (3036)

Removing

- Remove the supercharger ribbed belt. Refer to => [ Supercharger Ribbed Belt ] Supercharger Ribbed Belt.

- Remove the bolt - 2 - on the left front coolant pipes.






• The installed position is shown in the illustration with the engine removed.

• Ignore - 1 -.

- Remove the bolts - 2 - on the left front coolant pipes.






• Ignore - 1 and 3 -.

- Pivot the tensioner clockwise - arrow - to release the tension on the ribbed belt.






- Remove the ribbed belt from the vibration damper and release the tension on the tensioning element.

• Ignore (T10060 A).

- Remove the vibration damper bolts - 1 -; to do this, counter hold it using the (3036).






- Remove the vibration damper.

Installing

Install in reverse order of removal. Note the following:

• Tightening specifications, refer to => [ Ribbed Belt Drive Overview ] Ribbed Belt Drive Overview.

• Replace bolts which have been tightened to an additional torque.

• Installation is only possible in one position because of the offset holes.

- Install the left front coolant pipes. Refer to => [ Left Front Coolant Pipes ] Left Front Coolant Pipes.

- Install the ribbed belt. Refer to => [ Ribbed Belt ] Ribbed Belt.