End Plate

End Plate

Removing






- Remove front wheel housing liner. Refer to => [ Front Wheel Housing Liner ] Front Wheel Housing Liner.

- Left side: remove the windshield washer fluid reservoir.

- Remove the expanding rivets - 4 -.

- Remove the guides on the upper end plate - 3 - on the fender flange - 2 -.

- Remove the end plate - 1 -.

Installing






• For the correct tightening specifications, refer to => [ Fender Assembly Overview ] Fender Assembly Overview.

Installation is reverse of removal, but note the following:

- The guides - arrows - on the upper end plate - 1 - must be pushed onto the fender flange - 2 -.

- Left side: install the windshield washer fluid reservoir.

- Install the front wheel housing liner, refer to => [ Front Wheel Housing Liner ] Front Wheel Housing Liner.