Rear Bench Seat

Rear Bench Seat

Removing






- Move the front seats all the way forward.

- Unclip the LATCH child seat anchor guides (quantity: 4) - 1 - from anchorages - 2 -. Refer to => [ LATCH Child Seat Anchor Guide, Rear Seat ] LATCH Child Seat Anchor Guide, Rear Seat.

- With both hands, grasp the rear seat bench under the seat frame.






- Pull the rear seat bench - 1 - up forcefully with both hands - A arrows - so the wire hooks - 2 - on the rear seat bench disengage from the mounting grommet - 3 -.

- Repeat the procedure on the other side of the rear seat bench - B arrows -.

- Vehicles with seat heating: disconnect the seat heating connector

- Remove rear seat bench from the vehicle.

Installation






Install in reverse order of removal. Note the following:

- Lift floor covering - 3 - and press in new mounting grommets until they engage audibly in body opening - 1 -.

- Place floor covering around grommet as illustrated.

• The floor panel into which the mounting grommets are inserted must be checked after every disassembly of the rear bench seat and be readjusted in the case of deformation, refer to => [ Floor Panel for Rear Bench Seat Mounting Grommets and Wire Frame, Checking and Aligning ] Floor Panel For Rear Bench Seat Mounting Grommets and Wire Frame, Checking and Aligning.

• Floor covering - 3 - may not be on grommet - 2 -.

• Make sure the seat heating electrical collections slide on and engage audibly.

- Install the rear seat bench and push the wire hook - 1 - forcefully into the grommets - 2 - - arrow -.






- Make sure the wire hooks are engaged correctly in the grommets.

Information for installation: for example tightening specifications, replacing body parts, refer to => [ Rear Seat Bench Assembly Overview ] Rear Seat Bench Assembly Overview.