Sill Side Trim With Front Trim

Sill Side Trim with Front Trim

Removing






- Move the front seat all the way to the rear and then into its highest position.

- Move the seat depth adjuster to the rear.

- Release lower retaining tabs - 2 - on the holder - 3 - and pull front trim - 1 - upward - A, B arrows -.

- Move the front seat all the way forward/up.






- Remove the front belt anchor. Refer to => [ Front Belt End Fitting ] Front Belt End Fitting.

- Pull sill side trim - 1 - upward and detach at the holder - A, B, C arrows - by releasing the lower retaining tabs - 2 - on the holder - 3 -.

- Pull off sill side trim - 2 - together with front trim - 1 - - A and B arrows - and remove.






• In order to prevent damage, make sure that all retaining tabs - 4 - on the holder - 3 - are correctly released.

- Disconnect the connectors:






1. Front seat switch module (E663) / (E664)

2. Massage button (E670) / (E671)

3. Front seat switch module 2 (E667) / (E668)


- Free up electrical wire on the bracket - 4 -.

- Remove sill side trim.

- Disconnect sill side trim - 1 - from the front trim - 2 - by releasing retaining tabs - arrows -.






Installation

Install in reverse order of removal. Note the following:

• Make sure the connectors are installed all the way in and are secure.

• Route the connectors and wires as illustrated.

Information for installation: for example tightening specifications, replacing body parts, refer to => [ Sill and Tunnel Side Front Trim Assembly Overview ] Sill and Tunnel Side Front Trim Assembly Overview.