Front Bumper Cover Mount

Front Bumper Cover Mount

Removing






- Remove the front bumper cover. Refer to => [ Front Bumper Cover ] Front Bumper Cover.

- Loosen the bolt - 1 - three turns.

- Remove the bolts - 2 and 3 - and the mount - 4 - from the front bumper cover mount.

Installing






• Gap dimensions, refer to => [ Front Bumper Cover Gap Dimensions ] Front Bumper Cover Gap Dimensions.

• Tightening specifications, refer to => [ Bumper Cover Assembly Overview ] Bumper Cover Assembly Overview.

Installation is reverse of removal, but note the following:

- Press the front bumper cover mount - 3 - against the headlamp housing - 2 - - arrow -, hold it in this position and then tighten the bolt - 1 -.

• The rib - 4 - on the mount must touch the headlamp housing.

- Install the front bumper cover. Refer to => [ Front Bumper Cover ] Front Bumper Cover.