Lane Change Assistance, Preparing For Calibration

Lane Change Assistance, Preparing for Calibration






1 Distance Laser (VAS 6350/2)

• For distance measurement

• Refer to the Operating Instructions that come with the Calibration Tool (VAS 6350).

2 Calibration Tool For Lane Changing Assist (VAS 6350)

3 Water Level

• On Calibration Device (VAS 6350)

• To check horizontal position of Calibration Device (VAS 6350).

4 Catch Bracket

• For mounting distance laser (VAS 6350/2) for distance measurement.

• Distance to wheel center sensors (VAS 6350/1) on rear wheels: Dimension - a - = 1700 ± 2 mm.

5 Lane Change Assistance Calibration Device (VAS 6350/4)

• Is moved from right to left side of measuring field during calibration.

• When installed correctly, vehicle electrical system voltage line must be connected at bottom left of calibration device (as seen in direction of travel).

6 Wheel Center Sensor (VAS 6350/1)

• With wheel bolt adapter SW 16 and measuring paddle.

7 Brand Emblem

• The laser point is aligned on the center of the brand emblem.

8 Measurement Scale

• For positioning Lane Change Assistance Calibration Device (VAS 6350/4).

9 Line Laser (VAS 6350/3)

• With "Laser eye protection"

• On Calibration Device (VAS 6350)

• Turning on and off, refer to the Operating Instructions that come with the Calibration Tool (VAS 6350).

10 Plastic Foot

• Quantity 3

• Adjustable in order to adjust horizontal position of Calibration Device (VAS 6350).