Pass-Through Cover Lock Cylinder

Pass-Through Cover Lock Cylinder

Removing






- Fold center armrest up.

Only remove and install the lock cylinder with the key inserted correctly. If that is not done, the tumblers and compression springs can fall out and the lock cylinder will be ruined.

- Insert the key - 3 - into the lock cylinder - 2 - correctly.

- Turn the key 90° counterclockwise.

- Move the pass-through door handle - 1 - all the way up.

- Disengage the retaining tabs - lower arrows - and press the lock cylinder and key out of the handle.

• Ignore the - top arrow - in this figure.

Installing

Install in reverse order of removal. Note the following:

• Only remove and install the lock cylinder with the key inserted correctly. If that is not done, the tumblers and compression springs can fall out and the lock cylinder will be ruined.

• Check the installation position when installing the lock cylinder. It is not possible to lock the backrest correctly if the installation position is not correct.

- Slide the lock - 3 - into the new lock cylinder - 2 - correctly.






- Remove the protective cap - 4 - from the new lock cylinder.

- Insert the lock cylinder in the pass-through door handle - 1 -.

• Installation position of the lock cylinder: the key slot must be vertical and the retaining tabs - upper arrow - must point to the right, opposite the direction of travel.

- Turn the key 90° clockwise.

• Make sure the lock cylinder is correctly installed into the retainers - lower arrows -.