FREE REPAIR MANUALS & LABOR GUIDES 1982-2013 Vehicles
Courtesy of Operation CHARM: Car repair manuals for everyone.
Home >> Audi >> 2012 >> A4 Quattro Wagon (8K5) L4-2.0L Turbo (CAEB) >> Repair and Diagnosis >> Body and Frame >> Seats >> Service and Repair >> Removal and Replacement >> Manual (Standard) Front Seat >> Seat Height Adjustment

Seat Height Adjustment







Seat Height Adjustment

Removing

• Follow all safety precautions when working on pyrotechnic components.

• Before handling pyrotechnical components (for example, disconnecting the connector), the person handling them must discharge static electricity. For example, by briefly touching the door striker pin.

- Turn on the ignition.

- Disconnect the battery ground cable from the battery with the ignition on.

- Remove the front seat:

• Standard seat and Sport seat (manual). Refer to => [ Manual Standard Front Seat ] Manual Standard Front Seat.

- Attach the front seat to the (VAS 6136). Refer to => [ Front Seats, Installing on the ] Front Seats, Installing on the Fixture For Seat Repair (VAS 6136).

- Remove tunnel side trim panel. Refer to => [ Trim, Sill Side ] Trim, Sill Side.

- Remove bolts - 2 - (quantity: 2).






- Remove the seat height adjustment handle - 1 -.

- Remove the lock washer - 1 -.






• The bolts - 1 - and the bolt - 3 - are different lengths.






- Remove the bolts - 1 - (quantity: 2) and - 3 - (quantity: 5).

- Remove seat height adjuster - 2 -.

Installing

• Follow all safety precautions when working on pyrotechnic components.

• Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must discharge static electricity. For example, by briefly touching the door striker pin.

Install in reverse order of removal. Note the following:

• Make sure the connectors are installed all the way in and are secure.

Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.

- Connect the battery ground cable with the ignition turned on.

• If the airbag indicator lamp (K75) indicates a fault after installation, the DTC memory must be checked, deleted and checked again using the Vehicle Diagnostic Tester.

Tightening specifications, refer to => [ Seat Height Adjuster and Seat Height Adjustment Handle Overview ] Seat Height Adjuster and Seat Height Adjustment Handle Overview.

pro multis Credits:Operation CHARM About Operation CHARM