02EA Transmission

Transmission Oil Cooler

Special tools, testers and auxiliary items required

• Hose Clamps Up to 25 mm Dia. (3094)

• Engine Bung Set (VAS 6122)

Removing

4-Cylinder 2.0L TFSI Vehicles


Danger of breaking the engine cover.

• Always follow the removal sequence.

- Carefully remove the engine cover from - 1 - 2 - 3 - 4 -.






- Remove the air filter housing.









Risk of destroying electronic components when disconnecting the battery.

• Observe measures for disconnecting battery.

- Remove battery.

- Remove the bolts - arrows - and the battery carrier.

Vehicles with 6-Cylinder 3.2L Engine

- Remove the air filter housing and guide.






All Vehicles

- Mark coolant hoses to transmission fluid cooler to prevent mix-ups when installing.

- Remove the coolant hoses of the transmission fluid cooler with (3094) and remove from transmission oil cooler.






- Seal any open lines and connections with a clean plug from the (VAS 6122).

- Remove bolts - A -.






- Remove the transmission fluid cooler - B - together with both O-rings - C - from the transmission.

- Seal any open lines and connections with a clean plug from the (VAS 6122).


Coolant must not drip into transmission!

Installing

Install in reverse order, paying attention to the following:

• Tightening specification, refer to => [ Transmission Fluid Cooler and Filter Overview ] Description and Operation.

• The bolts - A - and O-rings - C - must be replaced.

- Install battery carrier and battery.

- Install the air filter housing.

- Check coolant level.

- Refer to => [ Transmission Fluid, Checking and Filling ] Transmission Fluid, Checking and Filling.