Engine and S-Tronic Transmission, Separating

Engine and S-Tronic Transmission, Separating

Special tools, testers and auxiliary items required

• Engine Sling (2024 A)

• Lifting Eyebolt (3368)

• Shop Crane -Load Cap=700-1200kg (VAS 6100)

• Self-locking collar nut M10

Procedure






• Engine/transmission assembly removed and mounted on (T10359).

- Free up the wires - arrows -.

- Remove the coolant hoses from the transmission oil cooler - arrows -.






• To prevent dirt from entering, seal open lines and connections with clean plugs or protective caps.

- Remove the bolts - 1 and 2 - and the starter.






- Tighten the (3368) a few turns on the transmission bracket with an M10 self-locking collar nut - arrow -.






- Engage the (2024 A) on the (VAS 6100) and on the transmission as shown in the illustration.






• To be aligned to the center of gravity of the engine assembly, the hole rails of the lifting hook must be inserted as shown in the illustration.


Loose engine support bridge components could cause an accident.

• Secure the mounting hooks and pins on the engine support bridge using securing pins - arrows -.

- Raise the transmission slightly.

- Remove engine to transmission connecting bolts - 1, 3, 5, 6, 7, 8, 9 and 10 -.






• Ignore items- 2, 4 and A -.

- Remove transmission from engine.