Rear Window Spray Nozzle, Adjusting

Rear Window Spray Nozzle, Adjusting

Special tools, testers and auxiliary items required

• Windshield washer aiming tool (T10127) fitted with replacement tip (3125/5 A)

Procedure






- Adjust nozzles using (T10127) so that the water jets are sprayed onto the rear window above the wipers at the points shown.

• Dimension - a - = approximately 125 mm.

• Dimension - b - = approximately 295 mm.

• Dimension - c - = approximately 5 mm.

- If the spray field does not correspond to the specifications, clean dirty spray jet.

Cleaning the nozzle

- Remove nozzle. Refer to => [ Rear Window Spray Nozzle ] Rear Window Spray Nozzle.

- Flush nozzle opposite to spray direction using clear water.

- To remove remaining impurities, the nozzle must only be blown out opposite to spray direction using compressed air.

- If the spray field still does not correspond to the specifications, replace the spray jet.