Front Door Window Motor: Service and Repair

Window Regulator Motor

Removing

- Door trim removed.

• The power window motor can be removed or installed with the motor or side window in any position.

• Before removing motor, disconnect electrical harness connectors.

- Remove TORX(R) bolts - 2 - (T30) and remove motor.






Installing

- When installing, make sure that threaded pins - 3 - are engaged in inner door plate - arrows -.

- Slide on window regulator motor - 1 - and secure with bolts - 2 -.

- Tightening specification: 3.5 Nm

• Only switch ignition on and off after installing motor and connecting wires.

• Then move door window upward to stop and keep pressing switch for window regulator for approximately 2 seconds longer.

• This position is the base position and the high- and low-running function is activated.